Custom-made to your opening · Supplied Australia-wide · Installed across Sydney
Horizontal slat fence panels stepped along a block retaining wall, with posts set to follow the fall of the ground.
Horizontal Slat Fencing
Repeating slat panels between posts, made to your bay size. The efficient way to fence a straight, level run.
Approximate is fine. Everything you choose here carries into your enquiry.
Custom configuration — enquire for pricing. Every product is made to your dimensions, so there is no list price.
Request a Custom QuoteMaterials and workmanship are covered by the consumer guarantees under Australian Consumer Law. Ask us about the cover that applies to your product before you order.
The detail
On a straight run over reasonably level ground, panels are the sensible way to build a slat fence. The run is divided into equal bays, one panel is made for that bay size, and it repeats. Fewer variables, less set-out, and a consistent result along the whole boundary.
The panels are still made to your dimensions — we size the bay to divide evenly into your run rather than making you accept a stock width and finish with an odd offcut at one end. That is the difference between a panel system and a made-to-measure panel: the repetition is a construction decision, not a limit on the size.
Slat spacing is where you choose how much this fence screens. Our garden boundary photo shows a tight spacing that reads almost solid from a few metres back, which is the usual choice for a boundary fence. Open it up and the same panel becomes a screen that defines the line without closing the outlook.
Panels can also sit on top of something else. The retaining wall photo in the gallery shows exactly that — slat panels mounted above a rendered block wall, with posts set to follow the fall of the ground so the top line stays level while the wall steps beneath it.
Specifications
Anything not listed here is set when we quote your project, because it depends on the size, the site and how the product is being fixed.
Questions
Compare
The closest alternatives, so you can check you are choosing the right one before you enquire.
Horizontal Slat
One leaf, hung on hinges, with flat aluminium slats running the width of the gate. The workhorse of side access — built to your opening rather than cut down from a stock size.
Horizontal Slat
Two leaves meeting in the middle, with horizontal slats running continuously across both. The standard answer for a driveway.
Horizontal Slat
One leaf that runs sideways instead of swinging. The answer when the driveway starts at the property line or a car parks right behind the gate.
Horizontal Slat
Made-to-measure slat fencing for runs that do not repeat: slopes, steps, curves in the boundary and awkward bays.
Send your opening size, the colour you want and a photo of the site. You will get a quote for your project rather than a price range.
Aluminium Horizontal Slat Fence Panels
Custom made — enquire for price
